Onkyo TX-SR876 Owner Manual - Page 101
tons to select 4. Level Calibra, tion, and then press [ENTER]. - weight
UPC - 751398008337
View all Onkyo TX-SR876 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Advanced Setup-Continued 3 Use the Up and Down [R]/[X] but- 5 tons to select "2. Speaker Setup", and then press [ENTER]. The "Speaker Setup" menu appears. 2. Speaker Setup 1. Speaker Settings 2. Speaker Config 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings 6. THX Audio Setup MOVE ENTER ENTER RETURN RETURN SETUP EXIT 4 Use the Up and Down [R]/[X] but- tons to select "4. Level Calibra- tion", and then press [ENTER]. The "Level Calibration" screen appears and the pink noise test tone is output by the front left speaker. 2-4. Level Calibration Left -12.0dB Center -12.0dB Right -12.0dB SurrRight -12.0dB SurrBack R -12.0dB SurrBack L -12.0dB SurrLeft -12.0dB Subwoofer -15.0dB Speaker A MOVE VALUE RETURN RETURN SETUP EXIT Note: Levels cannot be adjusted for speakers set to "No" or "None" in the Speaker Configuration (page 95). 6 7 Use the Up and Down [R]/[X] buttons to select a speaker, and use the Left and Right [F]/[S] buttons to adjust the level. Levels can be adjusted from -12 to +12 dB in 0.5 dB steps (-15 to +12 dB for the subwoofer). Notes: • You can set different levels for front Speakers A and front Speakers B, but not the other speakers (i.e., subwoofer, center, surround, and surr back). • The "Center" level cannot be set if the "Center" is set to "None" (page 95) or "Not Use" (page 98). • The "SurrRight" and "SurrLeft" levels cannot be set if the "Surround" is set to "None" (page 95) or "Not Use" (page 98). • The "SurrBack R" and "SurrBack L" levels cannot be set if "Speaker Type: Front(Speaker A) or Front(Speaker B)" is set to "Bi-Amp" or "BTL" (page 61), "SurrBack" is set to "None" (page 95) or "Not Use" (page 98), or "Powered Zone2" is being used (page 132). • The "Subwoofer" levels cannot be set if "Subwoofer" is set to "No" (page 96). Repeat step 5 until the volume of the test tone from each speaker is the same. If you're using a handheld sound level meter, adjust the level of each speaker so that it reads 75 dB SPL at the listening position, measured with C-weighting and slow reading. Press the [SETUP] button. Setup closes. Notes: • Speaker levels can also be adjusted by using the dedi- cated buttons on the remote controller. Press the [TEST TONE] button to output the test tone. Use the [CH SEL] button to select each speaker, and use the [LEVEL-] and [LEVEL+] buttons to adjust the level. • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 101