Onkyo TX-SR876 Owner Manual - Page 63
AM Frequency Step Setup (on some models), Changing the Input Display, Press the [TAPE] or [AUX
UPC - 751398008337
View all Onkyo TX-SR876 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
First Time Setup-Continued AM Frequency Step Setup (on some models) For AM tuning to work properly, you must specify the AM frequency step used in your area. Note that when this setting is changed, all radio presets are deleted. 1 Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. 2 Use the Up and Down [R]/[X] but- tons to select "7. Hardware Setup", and then press [ENTER]. The "Hardware Setup" menu appears. 7. Hardware Setup 1. Remote Control 2. Zone2/Zone3 3. Tuner 4. Analog Multich 5. HDMI 6. Network 5 Press the [SETUP] button. Setup closes. Note: This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. Changing the Input Display If you connect an V-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TAPE IN/OUT jacks, or connect an RI Dock to the AUX 1 jacks, for V to work properly, you must change this setting. This setting can only be changed on the AV receiver. 1, 2 1, 2 MOVE ENTER ENTER RETURN RETURN SETUP EXIT 3 Use the Up and Down [R]/[X] but- 1 tons to select "3. Tuner", and Press the [TAPE] or [AUX 1] input selector button so that "TAPE" or then press [ENTER]. "AUX1" appears on the display. The "Tuner" menu appears. or 7-3. Tuner AM Freq Step 9kHz 2 Press and hold down the [TAPE] or [AUX 1] input selector button VALUE RETURN RETURN SETUP EXIT (about 3 seconds) to change the setting. 4 Use the Up and Down [R]/[X] but- (3 seconds) Repeat this step to select MD, CDR, or tons to select "AM Freq Step", or DOCK. and then use the Left and Right [F]/[S] buttons to select: 10kHz: Select if 10 kHz steps are used in your area. For the TAPE input selector, the setting changes in this order: (3 seconds) TAPE → MD → CDR → → 9kHz: Select if 9 kHz steps are used DOCK in your area. For the AUX 1 input selector, the setting changes in this order: AUX1 ↔ DOCK Note: DOCK can be selected for the TAPE input selector or AUX 1 input selector, but not both at the same time. 63