Onkyo TX-SR876 Owner Manual - Page 96
tons to select Surround, and, tons to select Center, and then
UPC - 751398008337
View all Onkyo TX-SR876 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Advanced Setup-Continued 5 Use the Up and Down [R]/[X] but- 8 tons to select "Subwoofer", and then use the Left and Right [F]/[S] buttons to select: Yes: Select if a subwoofer is con- nected. No: Select if no subwoofer is con- nected. Note: The same setting is used for Speakers A and Speakers B. 6 Use the Up and Down [R]/[X] but- tons to select "Front", and then use the Left and Right [F]/[S] buttons to select a crossover fre- quency. 9 Notes: • This setting can be set independently for front Speakers A and front Speakers B. • Fixed at "Full Band" if "Subwoofer" (step 5) is set to "No". 7 Use the Up and Down [R]/[X] but- tons to select "Center", and then use the Left and Right [F]/[S] buttons to select a crossover fre- quency. If no center speaker is connected, select None. Notes: • The same setting is used for Speakers A and Speakers B. • Can be set if the currently selected 10 speakers (Speakers A or Speakers B) is set to "BTL" (page 61). • Cannot select "Full Band" if "Front" (step 6) is set to anything other than "Full Band". • For Speakers B, if any channel is set to "Full Band", "Center" is fixed at "Full Band". 96 Use the Up and Down [R]/[X] buttons to select "Surround", and then use the Left and Right [F]/[S] buttons to select a crossover frequency. If no surround left and right speakers are connected, select "None". Notes: • The same setting is used for Speakers A and Speakers B. • Can be set if the currently selected speakers (Speakers A or Speakers B) is set to "BTL" (page 61). • Cannot select "Full Band" if "Front" (step 6) is set to anything other than "Full Band". Use the Up and Down [R]/[X] buttons to select "SurrBack", and then use the Left and Right [F]/[S] buttons to select a crossover frequency. If no surround back speakers are connected, select "None". Notes: • The same setting is used for Speakers A and Speakers B. • Cannot be set if "Speaker Type: Front(Speaker A) or Front(Speaker B)" is set to "Bi-Amp" or "BTL" (page 61), "Surround" is set to "None" (step 8), or "Powered Zone2" is being used (page 132). • Cannot select "Full Band" if "Surround" (step 8) is set to anything other than "Full Band". Use the Up and Down [R]/[X] buttons to select "SurrBack Ch", and then use the Left and Right [F]/[S] buttons to select: 1ch: Select if one surround back speaker is connected. 2ch: Select if two (left and right) surround back speakers are connected. Notes: • The same setting is used for Speakers A and Speakers B. • Cannot be set if "Speaker Type: Front(Speaker A) or Front(Speaker B)" is set to "Bi-Amp" or "BTL" (page 61), "SurrBack" is set to "None" (step 9), or "Powered Zone2" is being used (page 132). Continue with step 11 on the next page.