Onkyo TX-SR876 Owner Manual - Page 97
Low-Pass Filter for the LFE Channel, Double Bass, OffTHX - tx b and q
UPC - 751398008337
View all Onkyo TX-SR876 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Advanced Setup-Continued Low-Pass Filter for the LFE Channel This setting is not set automatically by the Automatic Speaker Setup function (see page 64). With this setting, you can specify the cutoff frequency of the LFE channel's low-pass filter (LPF), which can be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel. *If you're using THX-certified speakers, select "80Hz(THX)". 11 Use the Up and Down [R]/[X] but- tons to select "LPF of LFE", and then use the Left and Right [F]/[S] buttons to select a low- pass filter frequency. The following low-pass filter frequencies can be selected: "80Hz(THX)", "90Hz", "100Hz", "110Hz", or "120Hz". Note: The same setting is used for Speakers A and Speakers B. Continue with step 12 in the next column. Double Bass This setting is not set automatically by the Automatic Speaker Setup function (see page 64). With this setting, you can boost bass output by feeding front left and right channel bass sounds to the subwoofer. This setting can only be made if the "Subwoofer" setting in step 4 is set to "Yes", and the "Front" setting in step 5 is set to "Full Band". *If you're using THX-certified speakers, select "Off(THX)". 12 Use the Up and Down [R]/[X] but- tons to select "DoubleBass", and then use the Left and Right [F]/[S] buttons to select: Off(THX): The subwoofer only outputs the LFE channel. On: In addition to LFE channel sounds, the subwoofer outputs front left and right channel bass sounds. Note: • The same setting is used for Speakers A and Speakers B. Continue with step 13 on the next page (TX-NR906 only). TX-SR876 continue with step 18 on page 99. 97