Onkyo TXSR705 Owner Manual - Page 105

TX-SR705_En.book Page 105 Thursday, May 31, 2007 1:20 AM Controlling Other Components-Continued Remote Control Codes for Onkyo Components Connected via Onkyo components that are connected via are controlled by pointing the remote controller at the AV receiver/AV amplifier, not the component. This allows you to control components that are out of view, in a rack, for example. 1 Make sure the Onkyo component is connected with an cable and an analog audio cable (RCA). See page 43 for details. 2 Enter the appropriate remote control code for the [DVD] or [CD] REMOTE MODE button. • [DVD] REMOTE MODE button 5002: Onkyo DVD player with • [CD] REMOTE MODE button 6002: Onkyo CD player with • [MD] REMOTE MODE button 6008: Onkyo MD recorder with • [CDR] REMOTE MODE button 6006: Onkyo CD recorder with • [DOCK] REMOTE MODE button 6004: Onkyo RI DOCK DS-A1 with See the previous page for how to enter remote control codes. 3 Press the [DVD] or [CD] REMOTE MODE button, point the remote controller at the AV receiver/AV amplifier, and operate the component. If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that's not connected via , use the following remote control codes: • [DVD] REMOTE MODE button 5001: Onkyo DVD player without (default) • [CD] REMOTE MODE button 6001: Onkyo CD player without (default) • [MD] REMOTE MODE button 6007: Onkyo MD recorder without • [CDR] REMOTE MODE button 6005: Onkyo CD recorder without • [DOCK] REMOTE MODE button 6003: Onkyo RI DOCK DS-A2 without (default) Note: If you connect an -capable Onkyo MiniDisc or CD recorder to the TAPE IN/OUT jacks, for remote operation to work properly, you must set the Input Display to MD or CDR, respectively (see page 50). Resetting REMOTE MODE Buttons You can reset a REMOTE MODE button to its default remote control code. 1 While holding down the REMOTE MODE button that you want to reset, press the TV [ ] button. The Remote indicator flashes three times. 2 Press the REMOTE MODE button again. The Remote indicator flashes twice, indicating that the button has been reset. The [DVD] and [CD] REMOTE MODE buttons are preprogrammed with remote control codes for controlling Onkyo DVD players and CD players respectively. When these buttons are reset, the preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 While holding down the [RECEIVER] REMOTE MODE but- ton, press the [STANDBY] button. The Remote indicator flashes five times. 2 Press the [RECEIVER] REMOTE MODE button again. The Remote indicator flashes twice, indicating that the remote controller has been reset. 105