Onkyo TXSR705 Owner Manual - Page 77
Speaker Settings, Speaker Configuration
UPC - 751398007804
View all Onkyo TXSR705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
TX-SR705_En.book Page 77 Friday, June 1, 2007 1:14 PM Advanced Setup-Continued Speaker Setup Some of the settings in this section are set automatically by the Automatic Speaker Setup function (see page 54). Here you can check the settings made by the Automatic Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using the Automatic Speaker Setup function. Note: The Speaker Setup cannot be carried out while headphones are connected to the AV receiver/AV amplifier. Speaker Settings See "Speaker Settings" on page 46. Speaker Configuration This setting is set automatically by the Automatic Speaker Setup function (see page 54). With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. The following crossover frequencies can be specified: Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 90 Hz, 100 Hz, 120 Hz, 150 Hz, or 200 Hz. Specify Full Band for speakers that can output low-frequency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by the subwoofer instead of the speaker. Refer to your speaker's manuals to determine the optimum crossover frequencies. Please note that any THX main speakers should be set to Small [80 Hz (THX)]. If you set up your speakers using the Automatic Speaker Setup function, please make sure manually that any THX speakers are set to Small with 80 Hz (THX) crossover. 1 2, 3 2-11 1, 12 1 2 ENTER ENTER 3 ENTER ENTER 4 ENTER ENTER Press the [RECEIVER] button followed by the [SETUP] button. The main menu appears onscreen. Use the Up and Down [ ]/[ ] buttons to select "2. Speaker Setup," and then press [ENTER]. The Speaker Setup menu appears. 2. Speaker Setup 1. Speaker Settings 2. Speaker Config 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings 6. THX Audio Setup Use the Up and Down [ ]/[ ] buttons to select "2. Speaker Config," and then press [ENTER]. The Speaker Config menu appears. 2-2. Speaker Config Subwoofer Yes Front 80Hz Center 80Hz Surround 80Hz Surr Back 80Hz Surr Back Ch 2ch LPF of LFE 80Hz Double Bass Off Use the Up and Down [ ]/[ ] buttons to select "Subwoofer," and then use the Left and Right [ ]/[ ] buttons to select: Yes: Select if a subwoofer is connected. No: Select if no subwoofer is connected. 77