Onkyo TXSR705 Owner Manual - Page 14
Remote Controller
UPC - 751398007804
View all Onkyo TXSR705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
2_Intro_En.fm Page 14 Tuesday, May 29, 2007 3:43 PM Remote Controller Installing the Batteries 1 To open the battery compartment, press the small hollow and slide off the cover. Aiming the Remote Controller To use the remote controller, point it at the AV receiver/AV amplifier's remote control sensor, as shown below. Remote control sensor STANDBY indicator AV receiver/AV amplifier 2 Insert the three supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment. 3 Put the cover onto the remote controller and slide it shut. Notes: • If the remote controller doesn't work reliably, try replacing the batteries. • Don't mix new and old batteries or different types of batteries. • If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion. • Expired batteries should be removed as soon as possible to prevent damage from leakage or corrosion. Approx. 16 ft. (5 m) Notes: • The remote controller may not work reliably if the AV receiver/ AV amplifier is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing. • If another remote controller of the same type is used in the same room, or the AV receiver/AV amplifier is installed close to equipment that uses infrared rays, the remote controller may not work reliably. • Don't put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. • The remote controller may not work reliably if the AV receiver/AV amplifier is installed in a rack behind colored glass doors. Keep this in mind when installing. • The remote controller will not work if there's an obstacle between it and the AV receiver/AV amplifier's remote control sensor. 14