Onkyo TXSR705 Owner Manual - Page 23
Speaker Connection Precautions, Connecting the Speaker Cables - av
UPC - 751398007804
View all Onkyo TXSR705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
TX-SR705_En.book Page 23 Monday, May 28, 2007 2:13 PM Connecting the AV Receiver/AV Amplifier-Continued Speaker Connection Precautions Read the following before connecting your speakers: • North American models: Only connect speakers with an impedance of 6 ohms or higher. If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the built-in protection circuit may be activated. • Other models: You can connect speakers with an impedance of between 4 and 16 ohms. If the impedance of any of the connected speakers is 4 ohms or more, but less than 6 ohms, be sure to set the minimum speaker impedance to "4 ohms" (see page 46). If you use speakers with a lower impedance, and use the amplifier at high volume levels for a long period of time, the built-in protection circuit may be activated. • Disconnect the power cord from the wall outlet before making any connections. • Read the instructions supplied with your speakers. • Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive (+) terminals, and negative (-) terminals only to negative (-) terminals. If you get them the wrong way around, the sound will be out of phase and will sound unnatural. • Unnecessarily long, or very thin speaker cables may affect the sound quality and should be avoided. • If you use 4 or 5 speakers, connect each of the two surround speakers to the SURR SPEAKERS terminals. Do not connect them to the SURR BACK SPEAKERS terminals. • Be careful not to short the positive and negative wires. Doing so may damage the AV receiver/AV amplifier. • Make sure the metal core of the wire does not have contact with the AV receiver/ AV amplifier's rear panel. Doing so may damage the AV receiver/AV amplifier. • Don't connect more than one cable to each speaker terminal. Doing so may damage the AV receiver/AV amplifier. • Don't connect one speaker to several terminals. Connecting the Speaker Cables 1 Strip about 5/8" (15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 2 Unscrew the terminal. 5/8" (15 mm) 3 Fully insert the bare wires. 4 Screw the terminal tight. The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one surround back speaker, connect it to the left (L) SURR BACK SPEAKERS terminals. Surround Surround Surround Surround back left back right left right speaker speaker speaker speaker Front right Front left Center speaker speaker speaker 23