Onkyo TXSR705 Owner Manual - Page 99

TX-SR705_En.book Page 99 Monday, May 28, 2007 2:13 PM Zone 2 Connecting Zone 2 With the Zone 2 function, you can enjoy one input source in the main room and a different source in another room. There are two connection methods: using a receiver/integrated amp in Zone 2 or using only a pair of speakers in Zone 2. Note: For speaker connections and related cautions, see page 23. Using a Receiver/Integrated Amp in Zone 2 With this connection method, you can use 7.1 surround sound in the main room and play a different AV source in Zone 2. The volume for Zone 2 is set on the receiver/ integrated amp. • Use an RCA audio cable to connect the AV receiver/ AV amplifier's ZONE 2 LINE OUT L/R jacks to an analog audio input on your receiver/integrated amp. • Connect the Zone 2 speakers to the speaker terminals on the receiver/integrated amp. Main room Using Only Speakers in Zone 2 With this connection method, you can use 5.1 surround sound in the main room and play a different AV source in Zone 2. The volume for Zone 2 is set on the AV receiver/AV amplifier. • Set the Powered Zone2 setting to "Act" (see page 100). • Connect your Zone 2 speakers to the AV receiver/AV amplifier's ZONE 2 SPEAKERS terminals. Main room TV AV receiver/AV amplifier TV Zone 2 AV receiver/AV amplifier L R Zone 2 ZONE 2 LINE OUT L R IN R L Receiver/ integrated amp Zone 2 12V Trigger When Zone 2 is turned on, the output from the ZONE 2 12V TRIGGER OUT goes high (+12 volts, 100 milliamperes max). Connecting this jack to a 12-volt trigger input on a component in Zone 2 will make that component turn on or off as and when Zone 2 is turned on or off on the AV receiver/AV amplifier. 99