Panasonic AJHD1700P AJHD1700 User Guide - Page 106

Setup menus The system menu and setup menu have some items whose settings differ and other items with which no selection options are displayed and whose settings are fixed (indicated by the shading in the table below), depending on the switching of the operation mode in response to the setting selected for system menu item No.25 (SYSTEM FREQ). (Refer to the table below.) System menu and setup menu settings • Each of the items whose settings differ is saved in the VTR MEMORY (current file and one of the backup files 1 to 4). The settings that correspond to each operation mode will be displayed so that the settings can be performed for each operation mode. Registration of the and function buttons • When the items whose settings differ have been registered in the and function buttons, the settings that correspond to each operation mode will be displayed so that the settings can be performed for each operation mode. • If items, whose selection options are not displayed due to the operation mode, have been registered in the or function button, when an operation mode in which these options are not displayed is selected, what has been registered is saved but the function button itself will become blank and cannot be operated. Bear in mind, however, that when the data is registered again, it is saved by overwriting the existing data so that the previously registered data will be lost. 50-pin connector registration • When the items whose settings differ have been registered in the 50-pin connector pins, the settings corresponding to the operation modes are allocated to the IN and OUT pins on the basis of the setting numbers. However, when the upper limit value is exceeded, the value will be limited to this upper limit. What has been registered is saved, but bear in mind that when the data is registered again, it is saved by overwriting the existing data so that the previously registered data will be lost. • If items, whose selection options are not displayed due to the operation mode, have been registered in the 50-pin connector, when an operation mode in which these options are not displayed is selected, what has been registered is saved but no operation is possible. Bear in mind, however, that when the data is registered again, it is saved by overwriting the existing data so that the previously registered data will be lost. System menu No. 12 14 15 16 Menu item SYS H (HD) SYS SC (SD) VO SYS H (SD) SD SYS D (SD) COARSE FINE COARSE FINE COARSE FINE System menu No.25 (SYSTEM FREQ) 59/60 23/24 50 25 (HD) j5H to 0H to 5H j5H to 0H to 5H j5H to 0H to 5H j1100 to 0 to 1100 j1375 to 0 to 1375 j1320 to 0 to 1320 j108 to 0 to 108 j115 to 0 to 115 j5H to 0H to 5H j5H to 0H to 5H j858 to 0 to 858 j864 to 0 to 864 j5H to 0H to 5H j5H to 0H to 5H j858 to 0 to 858 j864 to 0 to 864 25 (SD) Setup menus No. 109 501 502 Menu item CAP.LOCK VITC POS-1 VITC POS-2 600 VIDEO IN SEL 59/60 2F/4F 10L to 16L to 20L 10L to 18L to 20L INTSG HDSDI SDTI SDSDI The underlining (__) denotes the factory setting mode. (Continued on next page) 106 System menu No.25 (SYSTEM FREQ) 23/24 50 25 (HD) 2F 2F/4F/8F 2F 7L to 11L to 22L 7L to 13L to 22L INTSG HDSDI SDSDI 25 (SD) 2F 7L to 11L to 22L 7L to 13L to 22L