Panasonic AJHD1700P AJHD1700 User Guide - Page 87
Interface, Rs232c Sel
View all Panasonic AJHD1700P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Setup menus No./Item Description of setting 200 PARA RUN 202 ID SEL 204 RS232C SEL 205 BAUD RATE 206 DATA LENGTH 207 STOP BIT 208 PARITY For selecting whether to operate two or more VTRs in synchronization. 0000 DIS: The VTRs are not operated in synchronization. 0001 ENA: The VTRs are operated in synchronization. To operate the VTRs in synchronization, set all the VTRs to 1 (ENA). (Refer to pages 14 and 19.) For setting what ID information is to be returned to the controller. 0000 OTHER 0001 DVCPRO 0002 ORIG • For 0 (OTHER), the ID information of VTRs other than DVCPRO models is set. • Select 2 (ORIG) only when the VTR is connected to a Panasonic controller (such as the AJ-A900, an optional accessory). • Select 1 (DVCPRO) or 2 (ORIG) if the 23/24 Hz mode has been selected by system menu item No.25 (SYSTEM FREQ). For selecting whether the RS-232C connector is to function. 0000 OFF: The RS-232C connector does not function. 0001 ON: The RS-232C connector functions. For setting the RS-232C data transfer speed (baud rate). 0000 300 0001 600 0002 1200 0003 2400 0004 4800 0005 9600 For setting the RS-232C data length. (Unit: bits) 0000 7 0001 8 For setting the number of RS-232C stop bits. (Unit: bits) 0000 1 0001 2 For setting whether the RS-232C parity bit is to be used and, if it is used, whether even or odd parity is to apply. 0000 NON: The parity bit is not used. 0001 ODD: The parity bit is used with an odd parity. 0002 EVEN: The parity bit is used with an even parity. No./Item Description of setting 209 RETURN ACK For setting whether or not to return the ACK code when a command is received from RS232C. 0000 OFF: The ACK code is not returned. 0001 ON: The ACK code is returned. 212 MASTER PORT For selecting the remote control connector for controlling the slave machine when this VTR is to be used as the master machine for deck-to-deck operations. 0001 IN/OUT: The IN/OUT connector is used. 0001 OUT: The OUT connector is used. This setting takes effect only when the 9P button has been set to LOCAL (LED off). The underlining (__) denotes the factory setting mode. 87