Panasonic AJHD1700P AJHD1700 User Guide - Page 55

DIAG Function menus The warnings and hour-meter can be checked on these menu screens. On the SHIFT menu screen, error log files can be checked, deleted or saved onto or loaded from IC cards. Warning mark SHIFT F1 F2 F3 F4 F5 F6 Warning messages which are saved Description (Refer to page 118 and following.) NO RF A blank section on the tape lasting more than 1 second has been detected. (During normal playback) SV NOT LOCKED The servo has been disengaged for more than 3 seconds. (During recording, normal playback or editing) LOW RF HIGH ERROR RATE An envelope level which is about 1/3 of normal or a CTL level which is about 1/6 of normal has been detected for more than 1 second. (During recording, normal playback or editing) The error rate has deteriorated, and correction or compensation has been applied to the video or audio playback signals. (During normal playback) Warning display When a warning occurs in this VTR, the warning mark (W) blinks at the top left of the screen. If F1 (WARN) is now pressed, the details of the warning can be checked out on the LCD monitor. When more than one warning has occurred, turn the ADJ dial to scroll through the messages. Hour-meter display When F2 (HOURS) is pressed, the hour-meter information can be checked out on the LCD monitor. Error log function The error log mode can be selected by pressing the SHIFT button and switching the screen to . SHIFT F1 F2 F3 F4 F5 F6 General description When the following warnings have occurred while the tape is running, the warning messages, time codes and operating modes are saved, and a list of this information can be read out on the LCD monitor. Up to 99 warnings which have occurred can be saved. If the storage capacity of 99 warnings is exceeded, the processing that is conducted as a result is based on the setup menu item No.015 (AUTO STEP) setting. LCD monitor displays Operation mode display Saved warning status display Time code display Warning display Operation mode display This indicates the operation mode at the point when the warning was saved. Warning display This indicates the warning message which is saved. Saved warning status display This indicates the number of the currently displayed warning which has been saved and the total number of warnings which have been saved. Time code display This indicates the time code at the point when the warning was saved. Cueing up the tape to the warning point The warning list displayed on the LCD monitor can be scrolled by turning the ADJ dial. When the warning occurrence point to be checked is selected and the PREROLL button is pressed, the tape is cued up to the position of the time code which has been saved. 55