Panasonic DMC-G10 Operating Instructions - Page 144

Advanced (Playback) Note • The number of prints can be set from 0 to 999. • With a printer supporting PictBridge, the date print settings of the printer may take precedence so check if this is the case. • It may not be possible to use the print settings with other equipment. In this case, cancel all the settings, and reset the settings. • If the file is not based on the DCF standard, the print setting cannot be set. • [PRINT SET] cannot be set for pictures that were taken with the [QUALITY] set to [ ]. P [PROTECT] You can set protection for pictures you do not want to be deleted by mistake. Select [PROTECT] on the [PLAYBACK] Mode menu. (P28) Press 3/4 to select [SINGLE] or [MULTI] and then press [MENU/SET]. Select the picture, and then press [MENU/SET]. When [MULTI] has been selected • Repeat these steps for each picture. • The settings are canceled when [MENU/SET] is pressed again. [SINGLE] [MULTI] Press 2/1 to select Press 3/4/2/1 to the picture. select the pictures. Press [,] to return to the menu screen. • Press [MENU/SET] to close the menu. ∫ Canceling all the [PROTECT] settings 1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET]. 2 Press 3 to select [YES] and then press [MENU/SET]. 3 Press [MENU/SET] to close the menu. • If you press [MENU/SET] while canceling protection, the canceling will stop halfway. Note • The protect setting may not be effective on other equipment. • Even if you protect pictures on a card, they will be deleted if the card is formatted. • Even if you do not protect pictures on a card, they cannot be deleted when the card's Write-Protect switch is set to [LOCK]. 144 VQT2S62