Panasonic KX-HNC500 HomeHawk App Users Guide - Page 31

Getting started with the HomeHawk! *1 You can configure the camera so that its LED indicator does not light during normal operation or when motion is detected. See "HD camera device profiles", Page 171. Floor camera LED indicator Off Green R No power R LED indicator is turned off*1 Registration successfully completed*3 or signal level is strong*2 Registration mode, updating Camera is searching for your wireless router Blinking every 1.5 seconds Red Batteries for power backup are in use Registration failed*3, signal level is weak*2 Yellow R Streaming data*1 or detecting motion*1 R Accessing microSD card (when privacy mode is off) R Camera is out of range of your wireless router*2 R LED lights are abnormally hot R Wireless LAN connection failed Not registered to your wireless router (usually for initial setup), or signal level is good*2 Initial setup is being performed using WPS on your router Blue White Registration to your wireless router successfully completed or camera is on*1 Privacy mode is on*1 Accessing microSD card (when privacy mode is on) *1 You can configure the camera so that its LED indicator does not light in most states. See "Status", Page 109. *2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3 seconds. You can also check the signal level from "Camera signal strength", Page 109. *3 Lights for 3 seconds after registration is successfully completed or failed. Shelf camera LED indicator Off Green R No power R LED indicator is turned off*1 Registration successfully completed*3 or signal level is strong*2 Registration mode, updating Camera is searching for your wireless router Red Registration failed*3, signal level is weak*2 R Streaming data*1 or detecting motion*1 R Accessing microSD card (when privacy mode is off) 31