Panasonic PTDS8500U PTDS8500U User Guide - Page 80
Example of adjustment procedure, for brightness control, CONTROL SETUP] to [OFF],
UPC - 885170010994
View all Panasonic PTDS8500U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
PROJECTOR SETUP menu zzDetails of error Error message Remedial measure [Exceed maximum number of projectors.] •• Limit number of projectors in same group to 8. •• When linking 9 or more projectors, use a computer and the [Multi Projector Monitoring & Control Software]. [Please check the COMMAND CONTROL setting.] •• Turn [ON] the [COMMAND CONTROL] on the on-screen menu [NETWORK CONTROL] for the projector with the error display. •• Set [COMMAND PORT] of [NETWORK CONTROL] of all linked projectors to the same value. [Please check the USER NAME and PASSWORD in the COMMAND CONTROL setting.] •• Set the [USER NAME] and [PASSWORD] for the administrator authority for [WEB CONTROL] of all the linked projectors to the same text string. [Cannot apply BRIGHTNESS CONTROL. Please check projector status.] •• Projector is in standby state. Turn on power. [Brightness Sensor Error] •• There is a fault in the brightness sensor. If the fault is not corrected by turning the power off and back on, consult your dealer. Note zzIf the linked projectors are not listed, check the following. •• The devices on the network all have different IP addresses. •• The LAN cable is connected correctly. (Æpage 95) •• The sub-nets of the projectors are the same. •• The [LINKS] are set in the same group. zzFor changing the projector name, refer to "NETWORK ■ SETUP" of "NETWORK menu" (Æpage 94) or " Network config page" (Æpage 106). QQWhen [MODE] of brightness control is set to [PC] BRIGHTNESS CONTROL STATUS MODE PC PROJECTOR2 MENU RETURN The name of this projector is displayed. The state is indicated by color. GREEN : The brightness can be corrected by a significant margin. YELLOW : The brightness can no longer be corrected by a significant margin. RED : There is an error in brightness control. JJExample of adjustment procedure for brightness control The following is an example of adjustment procedure for linking the brightness of 8 projectors that form a network. 1111 Connect all the projectors to the hub using the LAN cables. (Æpage 5) 2222 Turn on the power in all projectors. 3333 Ensure [LAMP SELECT] of all the projectors are either all set to [DUAL] or all set to [SINGLE]. 4444 Set [MODE] of [BRIGHTNESS CONTROL SETUP] to [OFF], and select [APPLY]. 5555 Set [SUBNET MASK] of all the projectors to the same value and set their [IP ADDRESS] to different values so that network communication can be performed. 6666 Wait at least 8 minutes until the lamp power stabilizes. 7777 Set all the items in the [PICTURE] menu of all the projectors to the same value. 8888 To match the color, adjust [COLOR MATCHING]. Settings 80 - ENGLISH