Pentax K-7 K-7 Manual - Page 207

Setting the Image Finishing Tone 205 (Custom Image) You can set the image finishing tone before shooting. Select from the following seven modes for [Image Tone]: Bright (default setting), Natural, Portrait, Landscape, Vibrant, Muted and Monochrome. You can adjust the following items for [Image Tone]. Item Saturation*1 Hue*1 Settings Sets the color saturation. (Available settings: -4 to +4) Sets the color. (Available settings: -4 to +4) High/Low Key Adj Changes the brightness of the image. (Available settings: -4 to +4) Contrast Sets the image contrast. (Available settings: -4 to +4) You can also change the setting to Contrast Highlight Adjustment or Contrast Shadow Adjustment. Sharpness*2 Sets the sharpness of the image outlines. (Available settings: -4 to +4) Filter Effect*3 Changes the contrast to appear as if a B&W color filter was used. Sets the filter color. (Available settings: [None], [Green], [Yellow], [Orange], [Red], [Magenta], [Blue], [Cyan], 6 [Infrared Filter]) Toning*3 Sets the level for cold tone adjustment (- direction) and warm tone adjustment (+ direction). (Available settings: -4 to +4) *1 This can be set when any mode other than [Monochrome] is selected. *2 You can also change the setting to [Fine Sharpness], which makes image outlines even thinner and sharper. *3 This can be set when [Monochrome] is selected. Custom Image cannot be set when the mode dial is set to B (Green) or C (Movie) mode. 1 Press the four-way controller (5) in Capture mode. The Custom Image options screen appears. After the power is turned on, the last image taken is displayed in the background. Shooting Settings