Philips DVT1500 User manual - Page 18

Charging the rechargeable batteries in the, device, 3 Power on/off

Get Philips DVT1500 PDF manuals and user guides View all Philips DVT1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

4.2 Charging the rechargeable batteries in the device DVT3000 - DVT7000 Note 4.3 Power on/off 1 Slide the on/off switch on the side of the device downwards for approximately two seconds. XX The device turns on and the start-up screen is displayed. • The LFH9154 Philips rechargeable batteries can be charged in the device. Connect the device to a computer or use an external charger. • Fully charge the rechargeable batteries before first use. • A complete charging cycle takes about 2.5 hours. The computer must be turned on when charging the batteries. If the USB port of the computer does not supply enough power, use an external battery charger. 1 Plug the USB connector into a USB port on your computer. 2 To power off, pull down the power switch on the side of the device again and hold for about two seconds. 2 Insert the micro USB plug into the USB port on the bottom of the device. Note • The device switches itself off automatically if no key is pressed within a pre-set period of time (see also chapter 9.3.4 AUTOOFF, page 51). 18 First steps Table of contents

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
18
First steps
Table of contents
4.2 Charging the rechargeable batteries in the
device
DVT3000 – DVT7000
Note
• The LFH9154 Philips rechargeable batteries can be charged in
the device. Connect the device to a computer or use an external
charger.
• Fully charge the rechargeable batteries before first use.
• A complete charging cycle takes about 2.5 hours. The computer
must be turned on when charging the batteries. If the USB port
of the computer does not supply enough power, use an external
battery charger.
1
Plug the USB connector into a USB port on your computer.
2
Insert the micro USB plug into the USB port on the bottom of the
device.
4.3 Power on/off
1
Slide the on/off switch on the side of the device downwards for
approximately two seconds.
X
The device turns on and the start-up screen is displayed.
2
To power off, pull down the power switch on the side of the device
again and hold for about two seconds.
Note
• The device switches itself off automatically if no key is pressed
within a pre-set period of time
(see also chapter 9.3.4 AUTO-
OFF, page 51)
.