Pioneer DEH-P9800BT Owner's Manual - Page 93
Calibrating the RPMs, Activating the, source, Entering PIN code for, Bluetooth wireless connection, - display not working
UPC - 012562793962
View all Pioneer DEH-P9800BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Initial Settings Section 16 English Calibrating the RPMs Follow the instructions below to measure the RPM of your vehicle and records them. By doing this, the tachometer of this unit can work properly. ! Tachometer of this unit cannot work if you do not perform the RPM calibration. ! In some vehicles, the tachometer may not work properly even if you performed the RPM calibration. 1 Park your vehicle in a safe place and be sure to apply the parking brake. 2 Use MULTI-CONTROL to select Calibration. Calibration appears in the display. 3 Keep RPMs of the engine at 4 000 rpm and press MULTI-CONTROL. To measure the RPM of your vehicle properly, keep RPMs of the engine at 4 000 rpm for a few seconds. When the RPM calibration is completed, Completed is displayed. # Some vehicles have a rev limiter that kicks in early (e.g., 3 000 rpm) while parking. In this case, perform RPM measurement at 2 000 rpm. # To switch between 4000 rpm and 2000 rpm, push MULTI-CONTROL left or right. Activating the BT Audio source You need to activate the BT Audio source in order to use a Bluetooth audio player. 1 Use MULTI-CONTROL to select BT AUDIO. BT AUDIO appears in the display. 2 Press MULTI-CONTROL to turn the BT Audio source on. ON appears in the display. # To turn the BT Audio source off, press MULTI-CONTROL again. Entering PIN code for Bluetooth wireless connection To connect your cellular phone to this unit via Bluetooth wireless technology, you need to enter PIN code on your phone to verify the connection. The default code is 0000, but you can change this in this function. ! With some Bluetooth audio players, you may be required to enter to this unit in advance PIN code of your Bluetooth audio player, in order to set this unit ready for a connection from your Bluetooth audio player. 1 Use MULTI-CONTROL to select Pin code input. Pin code input appears in the display. 2 Push MULTI-CONTROL up or down to select a number. Pushing MULTI-CONTROL up or down changes the number. 3 Push MULTI-CONTROL right to move the cursor to the next position. When the number you want is displayed, push MULTI-CONTROL right to move the cursor to the next position and then select the next number. Push MULTI-CONTROL left to move backwards in the display. 4 After inputting PIN code (up to 16 digits), press MULTI-CONTROL. PIN code you entered is now standby to be stored in memory. En 93