Pioneer VSX-47TX Owner's Manual - Page 75

MULTI-ROOM setup SETUP 2 3~7 S0URCE TV SYSTEM RECEIVER OFF DVD/LD TV SAT MULTI CONTROL VCR1/ DVR VCR2 VIDEO TV CONT MULTI OPERATION CD CD-R/ TAPE1 TUNER RECEIVER DIMMER INPUT ATT LOUDNESS SPEAKER A/B 1 2 3 4 VIDEO SEL SIGNAL SEL 5 6 TAPE 2 EFFECT/CH SELL 7 8 TONE BASS/TREBLE 9 0 - +10 + DISC ENTER SYSTEM SETUP DIRECT ACCESS DISP MODE REMOTE SETUP MENU TUNER EDIT ENTER STATUS EXIT GUIDE RETURN MPX ¶ TUNING - 1 STATION - 4 CHANNEL - DTV ON/OFF 8 BAND 3 DTV MENU CLASS 7 EXTRA MENU TUNING + ¡ STATION + ¢ CHANNEL+ 1 2 3 4 System Setup [Auto Surround Setup] [1. Input Assign ] [2. Surround Setup ] [3. Expert Setup ] [4. THX Audio Setup ] 3.Expert Setup [1. OSD Adjustment ] [2. Bass Peak Level] [3. D-Range Control] [4. Multi-Ch In Select] [5. Function Renane] [6. Multi-Room Setting ] g] 4.6. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [PIONEER ] [Return] CAUTION: If the "FIXED" position is chosen,the volume will be loud. 4.6. Multi-Room Setting Volume Level [ FIXED ] IR Receiver [PIONEER ] [Return] 5 4.6. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [ OTHERS ] [Return] 6 3.6. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [ OTHERS ] [Return] CAUTION: If the "FIXED" position is chosen,the volume will be loud. Using Other Functions 1 Turn on the receiver, your TV and press RECEIVER on the remote control. Make sure your TV is set to the receiver. 2 Press the SYSTEM SETUP button then select EXPERT SETUP using 5 and ∞. Press ENTER. The EXPERT SETUP menu appears on the OSD. 3 Use the 5∞ buttons to select MULTI-ROOM SETTING . Press ENTER. 4 Select the VOLUME LEVEL by selecting VARIABLE or FIXED. If you hook up a just a power amplifier in the sub room the VSX-47TX will act as a pre-amp. In this case choose VARIABLE for the VOLUME LEVEL setting. If you hook up a full integrated amplifier in the sub room (such as another Pioneer VSX receiver) choose FIXED for the VOLUME LEVEL setting. CAUTION! If the MULTI ROOM is set to FIXED the volume on the main unit will be set to maximum. Thus, when output, it will be extremely loud. Please set the master volume controls of the integrated amplifier in the sub room very low at first and experiment to find the correct volume. 5 Select the IR RECEIVER type. If you have an IR receiver from a different company than PIONEER, select OTHERS. If you have the Pioneer-made MR-100, or the IR receiver you're using doesn't seem to work after selecting OTHERS, select PIONEER. 6 Select RETURN (use ∞5) then press ENTER to go back to the EXPERT SETUP menu. 7 Use the ∞5 buttons to select RETURN and press ENTER, again. Then use the ∞5 buttons to select EXIT and press ENTER. There may be some IR receivers that can't be memo used with this receiver. Check with a PIONEER representative to be sure. 75 EXPERT