Ricoh CL3500N Operating Instructions - Page 133
Displaying the signal strength - service mode
UPC - 026649024344
View all Ricoh CL3500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Making Printer Settings Using the Control Panel ❒ If the [HD Format] button is not displayed, the optional hard disk unit is not properly installed. Reinstall the optional hard disk unit. For details about the optional hard disk unit, see Setup Guide. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative. Displaying the signal strength Follow the procedure below to check the IEEE 802.11b (wireless LAN) signal on the [Maintenance] menu. A Press the {Menu} key. The [Menu] screen appears. B Press the {T} or {U} key to display [Maintenance], and then press the {# Enter} key. C Press the {T} or {U} key to display [WL.LAN Signal], and then press the {# Enter} key. Check the display for result. D Press the {Escape} key. The initial screen appears. ❒ If [WL.LAN Signal] is not displayed, [IEEE 802.11b] has not been selected for [LAN Type] in [Network Setup] on the [Host Interface] menu. Select [IEEE 802.11b] for [LAN Type], and then check that [WL.LAN Signal] is displayed on the [Maintenance] menu again. ❒ Signal status can be measured in [Infrastructure] under [Comm. Mode] of the wireless LAN. If [Ad hoc] or [802.11Ad hoc] is selected in [Comm. Mode], signal status cannot be measured. To measure signal status, select [Comm. Mode] in [Infrastructure] under [IEEE 802.11b] on the [Host Interface] menu. ❒ Every time you press the {# Enter} key, the signal is updated. 133