Ricoh CL3500N Operating Instructions - Page 196
View settings, Configuration
UPC - 026649024344
View all Ricoh CL3500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Monitoring and Configuring the Printer set Use the "set" command to set the protocol information display "active" or "inactive". ❖ View settings The following command displays protocol information (active/inactive). msh> set tcpip msh> set appletalk msh> set netware msh> set smb msh> set scsiprint • scsiprint is available when the optional IEEE 1394 interface board is installed. msh> set ip1394 • ip1394 can be specified only when the IEEE 1394 interface is installed. msh> set protocol • When protocol is specified, information about tcpip, appletalk, netware, and smb appears. msh> set lpr msh> set ftp msh> set rsh msh> set diprint msh> set web msh> set snmp msh> set ssl msh> set nrs msh> set rfu msh> set ipp msh> set http msh> set rendezvous ❖ Configuration • Enter "up"to enable protocol, and enter "down" to disable protocol. You can set the protocol to "active" or "inactive". msh> set tcpip {up | down} • If you disable TCP/IP, you cannot use remote access after logging off. If you did this by mistake, you can use the control panel to enable remote access via TCP/IP. 196