Ricoh CL3500N Operating Instructions - Page 200
Deleting sysLocation
UPC - 026649024344
View all Ricoh CL3500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Monitoring and Configuring the Printer Access type read write trap Type of access permission read only read and write user is notified of trap messages ❖ Protocol configuration msh> snmp {ip | ipx} {on | off} • Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive", all access settings for that protocol are disabled. • Specify "ip" for TCP/IP, or "ipx" for IPX/SPX. • {on} means "active" and {off} means "inactive". • IEEE 1394 interface is available for TCP/IP only. ❖ Configuration of protocol for each registration number msh> snmp "number" active {ip | ipx} {on | off} • To change the protocol of access settings, use the following command. However, if you have disabled a protocol with the above command, activating it here has no effect. ❖ Access configuration msh> snmp "number" {ip/addr | ipx} "address" • You can configure a host address according to the protocol used. • The network interface board accepts requests only from hosts that have addresses with access types of "read-only" or "read-write". Enter "0" to have network interface board accept requests from any host without requiring a specific type of access. • Enter a host address to deliver "trap" access type information to. • To specify TCP/IP, enter "ip" followed by a space, and then the IP address. • To specify IPX/SPX, enter "ipx" followed by a space, the IPX address followed by a decimal, and then the MAC address of the network interface board. ❖ sysLocation configuration msh> snmp location ❖ Deleting sysLocation msh> snmp clear location ❖ sysContact setting msh> snmp contact 200