Ricoh CL3500N Operating Instructions - Page 199
Protocol settings, View settings, Display, Community name configuration, Deleting community name,
UPC - 026649024344
View all Ricoh CL3500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Monitoring and Configuring the Printer ❖ Protocol settings msh> smb protocol [netbeui {up | down} | tcpip {up | down}] • Enable or disable NetBEUI and TCP/IP. Specify "up" to enable, and "down" to disable. snmp Use the "snmp" command to display and edit SNMP configuration settings such as the community name. ❖ View settings msh> snmp • Default access settings 1 is as follows: Community name:public IP address:0.0.0.0 Access type:read-only / trap off • Default access settings 2 is as follows: Community name:admin IP address:0.0.0.0 Access type:read-write / trap off • If "-p" is added, you can view settings one by one. • To display the current community, specify its registration number. ❖ Display msh> snmp ? ❖ Community name configuration msh> snmp "number" name "community_name" • You can configure ten SNMP access settings numbered 1-10. • The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if "public" is not registered in numbers 1-10. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings. • The community name can be entered using up to 15 characters. ❖ Deleting community name msh> snmp "number" clear "name" ❖ Access type configuration msh> snmp "number" type "access_type" Access type no Type of access permission not accessible 199