Ricoh CL3500N Operating Instructions - Page 207
Viewing settings, Configuration, Address configuration
UPC - 026649024344
View all Ricoh CL3500N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 207 highlights
Monitoring and Configuring the Printer Parameter auth {open|shared} rate {auto|11m|5.5m|2m|1m} Value configured You can set an authorization mode when using WEP. The specified value and authorized mode are as follows: open: open system authorized (default) shared: shared key authorized rate You can set the IEEE 802.11b transmitting speed. The speed you specify here is the speed at which data is sent. You can receive data at any speed. auto: automatically set (default) 11m: 11 Mbps fixed 5.5m: 5.5 Mbps fixed 2m: 2 Mbps fixed 1m: 1 Mbps fixed wins Use the "wins" command to configure WINS server settings. ❖ Viewing settings msh> wins • If the IP address obtained from DHCP differs from the WINS IP address, the DHCP address is the valid address. ❖ Configuration msh> wins "interface_name" {on | off} • {on} means "active" and {off} means "inactive". • Be sure to specify the interface. • ip1394 can be specified only when the IEEE 1394 interface is installed. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name ether ip1394 wlan Interface configured Ethernet interface IEEE 1394 interface IEEE 802.11b interface ❖ Address configuration Use the following command to configure a WINS server IP address: msh> wins "interface_name" {primary|secondary} "IP address" 207