Ricoh CL3500N Operating Instructions - Page 65

Preparing for Printing D When the message "Driver Files Search Results" appears, select the [Disable the device. The Add/Remove Hardware Wizard in the control Panel can be able to complete the driver installations.] check box, and then click [Finish]. Windows XP, Windows Server 2003 ❒ SCSI print must be set to "active" from the control panel. For details, see p.145 "Host Interface Menu". ❒ Installing this printer driver requires Administrators permission. Log on using an account that has Administrators permission. ❒ This printer can receive print data from one computer at a time only. If a job from a computer collides with other data, a message may appear on the computer. ❒ To install another printer driver after setting the "1394_00n" port, click [1394_00] as a port during the printer driver installation. ❒ When the printer driver is properly installed, connecting or disconnecting the optional IEEE 1394 cable causes the printer icon to change. A Connect the printer and computer using the IEEE 1394 interface cable. When the [Found New Hardware Wizard] dialog box appears, check that [This wizard helps you install software for: (Unknown)] is displayed. B Select the [Install from a list on specific location (Advanced)] check box, and then click [Next >]. C When the message "Please choose your search and installation op- tion." appears, select the [Search for the best driver in these locations.] check box, and then select the [Include this location in the search:] check box. D To disable Auto Run, press the left {SHIFT} key when inserting the CD- ROM into the drive and keep it pressed until the computer finishes reading from the CD-ROM. ❒ If Auto Run starts, click [Cancel], and then [Exit]. E Specify the location where the source files of the printer driver is stored, and then click [Next]. If the CD-ROM drive is D, the source files of the printer driver are stored in the following location: • RPCS D:DRIVESRPCSWIN2K_XP(Language)DISK1 65