Samsung CLP 300N User Manual (ENGLISH) - Page 24
Printing on Special Print Materials, Printing on Envelopes
UPC - 635753722093
View all Samsung CLP 300N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Printing on Special Print Materials Printing on Envelopes • Only use envelopes recommended for your printer. Before loading envelopes in the tray, make sure that they are undamaged and are not stuck together. • Do not feed stamped envelopes. • Never use envelopes with clasps, snaps, windows, coated linings, or self-stick adhesives. To print on envelope: 1 Squeeze the paper length guide and slide it out to its full length. 2 Load a sheet of envelope in the tray, with the flap side down. The end of the envelope with the stamp area enters the printer first. 3 Slide in the paper length guide until it lightly touches the end of the paper stack. 4 Slide the paper width guide to the edge of the envelope without causing it to bend. Printing on Labels • Only use labels recommended for your printer. • Verify that the labels' adhesive material can tolerate a fusing temperature of 180 °C (356 °F) for 0.1 seconds. • Make sure that there is no exposed adhesive material between the labels. Exposed areas can cause labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause damage to printer components. • Never print on the same sheet of labels more than once, or print on a partial sheet of labels. • Do not use labels that are separating from the backing sheet or are wrinkled or damaged in any way. • To prevent labels from sticking together, do not let the printed label sheets stack up as they are printed out. To print on label: 1 Squeeze the paper length guide and slide it out to its full length. 2 Load a sheet of label in the tray, with the print side up and the top, short edge in first. Adjust the guides to fit the length and width of the label. CAUTION: If you print 20 envelopes in succession, the surface of the top cover may become hot. Please exercise caution. 5 When you print, set the paper source to Manual Feed and the paper type to Envelope, and select the appropriate size in the software application. For details, see the Software Section. 6 Press the Stop button on the printer to start feeding. 3 When you print, set the paper source to Manual Feed and the paper type to Labels, and select the appropriate size in the software application. For details, see the Software Section. 4 Press the Stop button on the printer to start feeding. 3.3 Using Print Materials