Samsung SCX 6322DN User Manual (ENGLISH) - Page 85
Global Server not, Fuser Door Open - low heat error
UPC - 635753620658
View all Samsung SCX 6322DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Message Duplex Jam Open/Close Door File Access Denied File Name Exist File Name Over Limit Fuser Door Open Global Address Not Found Global Query Size Exceeded Global Server Auth Failed Global Server Communication Error Meaning Paper has jammed during duplex printing. Login to the network server was successful. However, access to the file on the network server was denied. The file name you have entered already exists. The file names you can use are from doc001 to doc999. However, all file names are used already. The fuser door is not securely latched. When the device is unable to locate the given address of the Global server. This is an error message and displays when the global query size has been exceeded. When there is a authentication fail while connecting to the global server this message displays. This error message displays when there is a communication error between the global server and the device. Suggested solutions Clear the jam. See page 14.6. Change the server settings. Enter a different file name. Delete unnecessary files. Open the rear cover and close the fuser door until it locks into place. For the location of the fuser door, see page 14.4. Check the search ID. There are too many search results. Refine your search by entering more letters. Contact a LDAP Server administrator. Check the authentication account and password. Try again. Contact a LDAP Server administrator. Message Global Server Not Configured Global Server not found Group Not Available [Incompatible] Invalid Server Address Line Busy [Line Error] Low Heat Error Cycle Power LSU Motor Error Cycle Power Meaning Suggested solutions When no global server is configured, this message displays. Check the LDAP server configuration settings. When the device is unable to find the Global server. Check the LDAP server address, The LDAP server address is incorrect, or the server has failed. You have tried to select a group location number where only a single location number can be used, such as when adding locations for a Multiple Send operation. Use a speed dial number or dial a number manually using the number keypad. The machine has received a fax from which is registered as a junk fax. The received fax data will be deleted. Reconfirm junk fax setup, see page 10.2. The server address you have entered is invalid. Enter the correct server address. The receiving fax machine did not answer or the line is already engaged. Try again after a few minutes. Your machine cannot connect with the receiving fax machine or has lost contact because of a problem with the phone line. Try again. If the problem persists, wait an hour or so for the line to clear and try again. Or, turn the ECM mode on. See page 10.1. There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. A problem has occurred in the LSU (Laser Scanning Unit). Unplug the power cord and plug it back inches. If the problem persists, please call for service. 14.7