Samsung SCX 6322DN User Manual (ENGLISH) - Page 86
One is, Over Heat Error - scanner locked
UPC - 635753620658
View all Samsung SCX 6322DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Message LSU Hsync Error Cycle Power Main Motor Locked Mail Exceeds Server Support Memory Full MP Tray Paper Empty Network Error [No Answer] Not Assigned [No Paper] Add Paper One Page is Too Large Open Heat Error Cycle Power Meaning Suggested solutions A problem has occurred in the LSU (Laser Scanning Unit). Unplug the power cord and plug it back inches. If the problem persists, please call for service. There is a problem in the main motor. Open and then close the front cover. The mail size is larger than the supported size by SMTP server. Divide your mail or reduce the resolution. The memory is full. Delete unnecessary fax jobs and retransmit after more memory becomes available. Alternatively, split the transmission into more than one operation. There is no paper in the multi-purpose tray. Load paper in the multi-purpose tray. See page 5.6. There is a problem with the network. Contact your network administrator. The receiving fax machine has not answered after several redial attempts. Try again. Make sure that the receiving machine is operational. The one-touch dial or speed dial number you tried to use has no number or email address assigned to it. Enter the number or email address manually using the number keypad or store the number or address. The paper in the tray Load paper in the has run out. tray. See page 5.5. Single page data exceeds the configured mail size. Reduce the resolution and try again. There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. Message Operation Not Assigned Over Heat Error Cycle Power Paper Jam 0 Open/Close Door Paper Jam 1 Open/Close Door Paper Jam 2 Check Inside Power Failure Replace Drum Retry Redial? Scanner locked Self Diagnostic LSU Self Diagnostic Temperature Send Error (AUTH) Meaning Suggested solutions You are in the Add Page/Cancel Job operation, but there are no jobs stored. Check the display to see if there are any scheduled jobs. There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. Paper has jammed in the feeding area of the tray. Clear the jam. See page 14.2 and page 14.3. Paper has jammed in the fuser area. Clear the jam. See page 14.4. Paper has jammed in the paper exit area. Clear the jam. See page 14.4. Power has turned off then on and the machine's memory has not been back up. The job which you were trying to do before the power failure must be completely re-done. The drum cartridge is at the end of its life. Replace the drum cartridge. See page 13.6. The machine is waiting for a specified time interval to redial a previously busy station. You can press OK to immediately redial, or Stop/Clear to cancel the redial operation. The scanner module is locked Unlock the scanner and press Stop/ Clear. The LSU (Laser Scanning Unit) in your printer is checking some problems detected. Please wait a few minutes. The engine in your machine is checking some problems detected. Please wait a few minutes. There is a problem in SMTP authentication. Configure the authentication setting. 14.8