Sanyo PLC-XD2200 RS232C Expand - Page 38

PLC-XD2200/2600 Expand Serial Command Functional Specifications 8.10.14 CF_P-MANE Command Command "CF_P MANE_%1"[CR] "OFF Set Power Management to OFF "READY Set Power Management to Ready "SHUTDOWN Set Power Management to Shut Down mode %1 "UP Switch Power management setting (Off → Ready → Shutdown → Off) "DN Switch Power management setting (Off → Shutdown → Ready → Off) Details Set/Cancel Power Management The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.15 CF_P-MANETIME Command Command "CF_P-MANETIME_%1"[CR] "01" ~ "30 Directly select setting time by the minute "UP Plus one minute (01 → 02 → → 30 → 01) "DN Minus one minute(30 → 29 → → 01 → 30) Details Set Power Management time The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.16 CF_ON-STA Command Command "CF_ON STA_%1"[CR] "ON Set Direct on active "OFF Set Direct on inactive %1 "UP Switch setting (On → Off → On → ) "DN Switch setting (On → Off → On → ) Note) "UP" and "DN" behave the same. Details Set/Cancel Direct On Start The status set by this command is stored in EEPROM and its setting is effective after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 38 / 71