Sanyo PLC-XD2200 RS232C Expand - Page 40

PLC-XD2200/2600 Expand Serial Command Functional Specifications 8.10.21 CF_KEYDIS Command Command "CF_KEYDIS_%1"[CR] "NONE RC & Projector keys are valid (All are valid) %1 "RC RC keys are invalid "KEY Projector keys are invalid Details Disable RC/Projector keys This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.22 CF_PJPINCODE Command Command "CF_PJPINCODE_%1"[CR] %1 "0000" - "9999" ---------Set PJ PIN CODE directly Set PJ PIN CODE to release PJ LOCK. PIN CODE cannot be changed by this command. Details -When PJ LOCK is in operation PIN CODE is correct Command is valid (Acceptable) PIN CODE is incorrect Command is invalid(Error Code"102") PIN CODE is out of %1 range Command is invalid (Error Code "? ") -When PJ LOCK is not in operation PIN CODE is within %1 range Command is valid (Acceptable) PIN CODE is out of %1 range Command is invalid (Error Code "? ") Response This command is valid during a dialog "PJ PIN CODE" is displayed after Power On and Count down. Also when PJ LOCK setting is "On1", it is necessary to transmit this command every time lamp turns on. Acceptable "000"[CR] Unacceptable "Error Code"[CR] 8.10.23 CF_FANMODE Command Command "CF_FANMODE_%1"[CR] %1 "L1 Set Fan Mode to L1 "L2 Set Fan Mode to L2 Details Switch Fan Mode When L1 is selected, fan noise after POWER OFF is louder. When L2 is selected, fan noise after POWER OFF becomes quiet, however, fan rotates longer than L1. The status set by this command is stored in EEPROM and its setting is effective even after ALL is OFF. This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 40 / 71