Sharp DV-HR300U DV-HR300U Operation Manual - Page 111
On-screen Error Messages
![]() |
View all Sharp DV-HR300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
On-screen Error Messages Messages Relating to DVD Discs and the HDD • The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the operation is not correct. Error message CANNOT PLAY BACK THIS DISC. THIS IS A NON-STANDARD DISC. REGION CODE OF DISC IS WRONG. DISC IS NOT INSERTED. CANNOT OPERATE THIS FUNCTION. DISC IS PROTECTED. COULD NOT REPAIR THE DISC. COULD NOT FINALIZE. THIS VIDEO IS COPY PROTECTED. RECORDING IS NOT POSSIBLE. CANNOT RECORD MORE. CANNOT RECORD ON THIS DISC. NO TAPE INSERTED IN DV CAMCORDER. CONNECTING TO DV CAMCORDER. COULD NOT INITIALIZE. DISC IS FULL. CANNOT RECORD OR STORE. THIS VIDEO CANNOT BE RECORDED TO THIS DISC. CAN'T DETECT CAMCORDER. SET THE DATE AND TIME. Possible Error • The disc cannot be played back with this Recorder. • If you load a disc which cannot be played with this Recorder (i.e. a scratched disc), or if you load a disc upside down, this message will appear, and the disc tray will automatically pop out. • Occurs if you load a DVD disc whose region number is not "ALL" or whose region number does not contain "1". • Occurs if no disc is loaded in the disc tray. • Occurs if operation is incorrect. • Occurs if you attempt to record or edit a disc for which disc protection is set. • Occurs if you attempt DV input of video which cannot be recorded, and attempt to record to a DVD. • If there is a power failure during DVD recording, the system automatically tries to recover data after power is restored. This error occurs if such recovery is impossible. • Occurs if the disc is scratched or dirty, etc. • Occurs if video with a copy guard signal is input. • Occurs if a title or chapter mark exceeds the recordable upper limit. • Number of titles: HDD 199/DVD 99. Number of chapters: HDD 999/ DVD 999 • Occurs if you load a disc which cannot be recorded to with this Recorder, or a disc which is scratched or dirty. • Occurs if you attempt operation when a tape has not been loaded in the digital camcorder linked via DV connection. • Occurs if the digital camcorder power goes off or the cable is pulled out while connecting to DV. • Occurs if connection with the digital camcorder is broken. • Occurs if the disc is scratched or dirty, etc. • Occurs if there is no empty space in the disc. • Occurs if you try to record a "Copy Once" broadcast onto a disc which is not compatible with CPRM. • Occurs if you set to DV input without connecting a digital camcorder. • Occurs if multiple digital camcorders are connected. • Occurs if timer programming is done when the Recorder clock has not been set. Suggested Solution • Check the disc, and load it correctly. • Cancel disc protection, or reload a recordable disc. • Check the disc, and load it correctly. • Cannot record. • Erase unnecessary titles. • Either erase unnecessary chapters, or combine chapters. • Reload an appropriate recording disc. • Load a tape into the digital camcorder. • Check the power of digital camcorder or cable connection. • System is performing reconnection processing. Wait about 30 seconds. • Check the disc, and load it correctly. • Load a disc with empty space. • Erase unnecessary titles. • Load a CPRM compatible disc (DVD- RW Ver. 1.1 or higher) initialized in VR mode. • Connect a digital camcorder, and reset again to DV input. • Set the clock and perform timer programming again. Continued on Next Page ||| 111
![](/manual_guide/products/sharp-dvhr300u-dvhr300u-operation-manual-cac2cfb/111.png)