Sony CAV-M1000ES Installation Manual Integrated A/V System - Page 33

Error Messages Other Information Main Unit If any of the messages below appear on the Display window of the Main Unit, check the following table to solve the problem. If any problem persists, consult your nearest Sony dealer. Message Cause Corrective action PROTECTOR ZONE1 Protective device in zone 1 has been activated. Turn off the Main Unit and check the speaker hookup. PROTECTOR ZONE2 Protective device in zone 2 has been activated. Turn off the Main Unit and check the speaker hookup. PROTECTOR ZONE3 Protective device in zone 3 has been activated. Turn off the Main Unit and check the speaker hookup. PROTECTOR ZONE4 Protective device in zone 4 has been activated. Turn off the Main Unit and check the speaker hookup. PROTECTOR ZONE5 Protective device in zone 5 has been activated. Turn off the Main Unit and check the speaker hookup. PROTECTOR ZONE6 Protective device in zone 6 has been activated. Turn off the Main Unit and check the speaker hookup. FAN STOP The fan does not rotate. Turn off the Main Unit and check that if any objects are inside the fan unit. CONNECTION ERROR STR A communication error with the A/V Receiver An error occurred due to an unsupported connection. (STR) has occurred. CONNECTION ERROR DVD MEGA A communication error with the DVD MEGA An error occurred due to an unsupported connection. CHANGER has occurred. CONNECTION ERROR CD MEGA A communication error with the CD MEGA An error occurred due to an unsupported connection. CHANGER has occurred. CONNECTION ERROR PC A communication error with the computer has An error occurred due to an unsupported connection. occurred. CONNECTION ERROR RF REMOTE A confirmation error with the RF Remote Control has occurred. Ask your nearest Sony dealer. EEP ACCESS FAIL The Main Unit failed to access the EEPROM. Ask your nearest Sony dealer. MEMORY FULL The Memory capacity for storing EEPROM code has been exceeded during the remote code learning. Some remote codes cannot be learned even if the memory capacity used for learning has not been exceeded. Keypad If any of the messages below appear on the display window of the Keypad, check the following table to solve the problem. If any problem persists, consult your nearest Sony dealer. Message Cause Corrective action CONNECTION NOT ESTABLISHED The Keypad failed to communicate with the Main Unit. Turn off the Main Unit and check the CAT5 connections. PROTECTOR Protector is detected by the Main Unit. Turn off the Main Unit and check the speaker connections. FAN STOP The fan of the Main Unit does not rotate. Turn off the Main Unit and check that the ventilation holes are not covered. PLEASE CHECK MODE SELECTOR Mode selector switch setting is wrong. Check that the Mode switch on the rear panel of the Keypad is in the correct position. CANNOT ACCESS NOW Multiple Keypads tried to access the same source component. Wait for a few seconds and try again. SOURCE NOT AVAILABLE! An inactive source was selected. Select the appropriate source connected to the Main Unit. LOCKED BY OTHER ZONE The selected source was locked by another zone. You cannot operate a locked source until it is unlocked. LOCKED BY MAIN ZONE The selected source was locked by the main You cannot operate a locked source until it is unlocked. zone. NOT USED An inactive button was selected. Some buttons are not assigned for certain sources. ex.) PLAY cannot be operated in the TUNER position. 33US