Sony DSC T1 Operating Instructions - Page 96
Others, You cannot identify an
UPC - 027242629608
View all Sony DSC T1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Others Symptom Your camera does not work. The power is on, but the camera does not work. You cannot identify an indicator on the LCD screen. The lens gets fogged. The camera becomes warm when you use it for a while. Cause • You are not using an "InfoLITHIUM" battery pack. • The battery level is low. (The E indicator appears.) • The AC Adaptor is not connected securely. • The camera is not properly installed to the USB cradle. • The built-in microcomputer is not working properly. - • Moisture condensation has occurred. - Solution p Use an "InfoLITHIUM" battery pack (page 111). p Charge the battery pack (page 11). p Connect it securely to the multi connector of your camera and to a wall outlet (wall socket) (page 15). p Properly install the camera (page 10). p Disconnect, and then, after one minute, reconnect all power sources and turn on the camera. If this does not work, press the RESET button on the lower side of the control button using a fine-tipped object, then turn on the power again. (All the settings including date and time are cleared.) p Check the indicator (pages 114 to 117). p Turn off the camera and leave for about an hour at room temperature for the moisture to evaporate before use (page 108). p This is not a malfunction. 96