Sony DSC V1 Operating Instructions - Page 98

Shooting still images/movies, P, S, A, M, SCN or

Page 98 highlights

Symptom The battery pack runs down too quickly. You cannot turn on the camera. The power turns off suddenly. Cause Solution • You are shooting/viewing images in an extremely cold location. • The DC plug is dirty so the battery pack is not charged enough. • The battery pack is dead (page 121). - p Clean the pins of the AC Adaptor with a cotton swab, etc., and charge the battery pack (page 10). p Replace the battery pack with a new one. • The battery pack is not installed correctly. • The AC Adaptor is disconnected. • The battery pack is discharged. • The battery pack is dead (page 121). p Install the battery pack correctly (page 10). p Properly connect the AC Adaptor (page 13). p Install a charged battery pack (page 10). p Replace the battery pack with a new one. • If you do not operate the camera for about three minutes when using a battery pack, the camera turns off automatically to prevent wearing down the battery (when [Power Save] is [On] after 90 seconds) (page 14). • The battery pack is discharged. p Turn on the camera again (page 14) or use the AC Adaptor (page 13). p Replace it with a charged battery pack (page 10). Shooting still images/movies Symptom Cause The LCD screen is not turned on even when the power is turned on. • The power was turned off with the LCD screen turned off the last time you used the camera. The subject is not visible • The mode dial is not set to , P, S, A, M, on the screen. SCN or (Clip Motion). The image is out of focus. • The subject is too close. • The (Twilight mode) or (Landscape mode) is selected for the Scene Selection function. • The focus preset function is selected. Solution p Turn on the LCD screen (page 28). p Set it to , P, S, A, M, SCN or (Clip Motion) (pages 20 and 79). p Record in the macro recording mode. Make sure to position the lens farther away from the subject than the shortest shooting distance when shooting (page 24). p Set it to other modes (page 63). p Cancel the function (page 49). 98

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132

98
Shooting still images/movies
The battery pack runs
down too quickly.
You are shooting/viewing images in an
extremely cold location.
The DC plug is dirty so the battery pack is not
charged enough.
The battery pack is dead (page 121).
p
Clean the pins of the AC Adaptor with a cotton swab, etc., and
charge the battery pack (page 10).
p
Replace the battery pack with a new one.
You cannot turn on the
camera.
The battery pack is not installed correctly.
The AC Adaptor is disconnected.
The battery pack is discharged.
The battery pack is dead (page 121).
p
Install the battery pack correctly (page 10).
p
Properly connect the AC Adaptor (page 13).
p
Install a charged battery pack (page 10).
p
Replace the battery pack with a new one.
The power turns off
suddenly.
If you do not operate the camera for about three
minutes when using a battery pack, the camera
turns off automatically to prevent wearing down
the battery (when [Power Save] is [On] after 90
seconds) (page 14).
The battery pack is discharged.
p
Turn on the camera again (page 14) or use the AC Adaptor
(page 13).
p
Replace it with a charged battery pack (page 10).
Symptom
Cause
Solution
The LCD screen is not
turned on even when the
power is turned on.
The power was turned off with the LCD screen
turned off the last time you used the camera.
p
Turn on the LCD screen (page 28).
The subject is not visible
on the screen.
The mode dial is not set to
, P, S, A, M,
SCN or
(Clip Motion).
p
Set it to
, P, S, A, M, SCN or
(Clip Motion) (pages 20
and 79).
The image is out of focus.
The subject is too close.
• The
(Twilight mode) or
(Landscape
mode) is selected for the Scene Selection
function.
The focus preset function is selected.
p
Record in the macro recording mode. Make sure to position the
lens farther away from the subject than the shortest shooting
distance when shooting (page 24).
p
Set it to other modes (page 63).
p
Cancel the function (page 49).
Symptom
Cause
Solution