Sony STR-D1015 Operating Instructions - Page 35
Specifications
View all Sony STR-D1015 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Specifications Audio Power Specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 8-ohm load, both channels driven, from 20 - 20,000 Hz, rated 120 watts per channel minimum RMS power, with no more thin 0.15 % total harmonic distortion from 250 milliwatts to rated outpist. Other Specifications Amplifier section Continuous RMS power output (8 ohms, at 20 Hz - 20 kHz less than 0.15 % total harmonic distortion) (FRONT) 123 W + 123 W Surround mode Surround mode (8 ohms at I kHz, THD 0.8 %) FRONT: 100 W/ch CENTER*: 100 W REAR: 25 W * (only in theDOLBY SUR and THEATER modes) Dynamic power output 165 W + 165 W (8 Ohms) 260 W + 260 W (4 ohms) Harmonic distortion at rated output Less than 0.15 % Frequency response PHONO: RIAA equalization curve *0.5 dB CD, DAT/MD, TAPE MONITOR, VIDEO 1,Z 3:10 Hz - 50 kHz'°, dB Inputs Sensitivity Impedance S/N Short A Net/78 IHF A Net PHONO (MM) CD 2.5 mV 300 mV 50 kilohms ! 75 dB/75 dB 50 kilohms ' 82 dB/82 dB DAT/MD, 250 mV TV, LD, VIDEO 1, Z 3, TAPE MONITOR 50 kilohms 82 dB/82 dB Outputs REC OUT VIDEO 1, 2 (AUDIO) OUT HEADPHONES Voltage 250 mV Impedance 10 kilohms Accepts low and high impedance headphons MUTING LOW BOOST TONE -20 dB +10 dB at 70 Hz ±8 dB at 100 Hz and 10 kHz FM tuner section Tuning range 87.5 -108.0 MHz Antenna terminals 75 ohms, unbalanced Sensitivity (at 50 dB): 18.3 dBf, 4.5 µV (mono) 38.3 dBf, 45 µV (stereo) Usable sensitivity 11.2 dBf, 2µV (IHF) S/N Mono: 76 dB Stereo: 70 dB Harmonic distortion at 1 kHz Mono: 0.3 % Stereo: 0.5 % Separation 45 dB at 1 kHz Frequency response 30 Hz -15 kHz:°23dB Selectivity 60 dB at 400 kHz AM tuner section Tuning range Antenna Usable sensitivity S/N Harmonic distortion Selectivity 530 -1710 kHz (with 10 kHz interval') 531 - 1710 kHz (with 9 kHz interval) Loop antenna 50 dB/m (at 1,000 kHz or 999 kHz) 54 dB (at 50 mV/m) 0.5% (50 mV/m, 400 Hz) 35 dB (9 kHz), 40 dB (10 kHz) " You can change the AM tuning interval to 9 kHz. After tuning in any AM tuning in any AM station, turn off the power of receiver once. While holding down the TUNING + button, press the POWER switch. When you change the interval, all the preset stations will be erased. To reset the interval, repeat the same procedure. Video section Inputs Outputs VIDEO 1,2,3: 1 Vp-p 75 ohms VIDEO 1, 2, MONITOR: 1 Vp-p 75 ohms General System Tuner section: PLL quartz-locked digital synthesizer system Preamplifier section Low-noise NF type equalizer Power amplifier section: Pure- complimentary SEPP Power requirements 120 V AC, 60 Hz Power consumption (in standby condition: 5W) USA model: 220 W Canada model: 310 VA AC outlets Two switched, total 120 W Dimensions 430 x 160 x 425 mm (17 x 6 2/, x 16 9/ 7 inches) Mass 13.1 kg (28 lb 14 oz) Supplied accessories FM wire antenna (1) AM loop antenna (1) Remote commander (1) Sony Batteries SUM-3(NS) (2) Design and specifications are subject to change without notice. 35