Sony STR-D1090 Operating Instructions - Page 42
Storing, Other, Manufacturer's, Operating, Codes, Remote, Commander, RM-P321
View all Sony STR-D1090 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Storing Other Manufacturer's Operating Codes Onto the Remote Commander RM-P321 Programming Signals of Other AudioNideo Equipment The remote commander RM-P321 supplied with the STR-D2090 learns various functions of other remote commanders emitting infrared rays and allows you to control most of audio and video equipment from a distance. When you manipulate a switch or button on the commander, be sure to point the head of the commander toward the remote control sensor on the front of the receiver. If there is an obstacle between the receiver and the head of the commander, the receiver may not be controlled remotely. 1,4 0 0 O 7000 nooc =HIM O 01O0 O 0 0 0000 0 OO 0 0 0 OCICsoloo= 0-kro-uror-% 0 coco= 0 OOOO r -ork 000100 I I 1 Set the mode selector to LEARN. USER STD SONY _ STD 11111L1E1ARN 2 Program a signal. The programmable buttons are changed according to the function mode. See "List of operative buttons in SYSTEM mode" on page 15. (th Select the appropriate function mode with the FUNCTION button when programming the signal in the buttons described in ID Other equipment control section" on page 14 (except the SELECT button). 02 Press and hold the button which shall "learn" the remote-control signal until the LEARN indicator lights up. Other manufacturer's remote commande Approx. 5 cm (2 inches) The LEARN indicator Programmable commander RM-P321 0 Press and hold the button of other manufacturers remote commander whose signal is to be learned. ® Remove your finger(s) from the button(s) after the LEARN indicator goes off. Note If the button which cannot be programmed is pressed in step 0, the LEARN indicator blinks. 3 Repeat operation for each button to be programmed. 4 Set the mode selector to USER STD or SONY STD. USER STD SONY STD ii LEARN Ninon 42