Sony STR-DA4600ES Operating Instructions (Large File - 17.22 MB) - Page 114
To output the source sound, adjacent speakers
View all Sony STR-DA4600ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Test Tone You can select the test tone type on the Test Tone screen. Tips • To adjust the level of all speakers at the same time, press MASTER VOLUME +/-. • The adjusted value is shown on the display during adjustment. To output a test tone from each speaker You can output a test tone from the speakers in sequence. 1 Select "Test Tone," then press . The Test Tone screen appears. 2 Adjust the parameter, then press . • OFF • AUTO The test tone is output from each speaker in sequence. • L, C, R, SR, SB*, SBR, SBL, SL, LH, RH, SW * "SB" appears when only one surround back speaker is connected. You can select which speakers will output the test tone. 3 Adjust "Level:," then press . To output a test tone from adjacent speakers You can output a test tone from adjacent speakers so that you can adjust the balance between the speakers. 1 Select "Phase Noise," then press . The Phase Noise screen appears. 2 Adjust the parameter, then press . • OFF • L/C, C/R, R/SL, R/SR, SR/SL, SR/SBR, SR/SB*, SBR/SBL, SB/SL*, SBL/SL, SL/L, L/SR, L/RH, LH/RH, LH/R * "SR/SB" and "SB/SL"appear when only one surround back speaker is connected. Lets you output the test tone sequentially from adjacent speakers. Some items may not be displayed, depending on the setting of the speaker pattern. 3 Adjust "Level:," then press . To output the source sound from adjacent speakers You can output the source sound from adjacent speakers so that you can adjust the balance between the speakers. 1 Select "Phase Audio," then press . The Phase Audio screen appears. 2 Adjust the parameter, then press . • OFF • L/C, C/R, R/SL, R/SR, SR/SL, SR/SBR, SR/SB*, SBR/SBL, SB/SL*, SBL/SL, SL/L, L/SR, L/RH, LH/RH, LH/R * "SR/SB" and "SB/SL"appear when only one surround back speaker is connected. Lets you output front 2 channel source sound (instead of the test tone) sequentially from adjacent speakers. Some items may not be displayed, depending on the setting of the speaker pattern. 3 Adjust "Level:," then press . Note When Dolby TrueHD, or Linear PCM signals with a sampling frequency of 176.4 kHz and higher are being received, sound is output only from the front left/right speakers. When a test tone is not output from the speakers • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have the short-circuit problem. 114GB