Sony STR-DA4600ES Operating Instructions (Large File - 17.22 MB) - Page 47

Getting Started On setting up the active subwoofer • When a subwoofer is connected, turn on the subwoofer and turn up the volume beforehand. Turn the LEVEL knob to just before the mid-point. • If you connect a subwoofer with the crossover frequency function, set the value to maximum. • If you connect a subwoofer with an auto standby function, set it to off (deactivated). 2)The measurement result is not utilized in the following cases. - The multi-channel input is selected. - "2ch Analog Direct" is being used. 3)The measurement result is not utilized when Dolby TrueHD, or Linear PCM signals with a sampling frequency of 176.4 kHz and higher are being received. 4)The measurement result is not utilized when signals with a sampling frequency of 88.2 kHz and higher are being received. Note Depending on the characteristics of the subwoofer you are using, the setup distance value may be further away from the actual position. To use the receiver as a preamplifier You can use the auto calibration function when you use the receiver as a pre-amplifier. In this case, the distance value shown on the display may differ from the actual distance value. However, there will be no problems, even if you continue to use the receiver with that value. Performing auto calibration The auto calibration function allows you to measure the following: • Speaker connections1) • Polarity of speakers • Speaker distance2) • Speaker size2) • Speaker level • Frequency characteristics (EQ)2) 3) • Frequency characteristics (Phase)2) 4) 1)The measurement result is not utilized when the multi-channel input is selected. V/v/B/b, RETURN/ EXIT O MENU 1 Press MENU. The menu is displayed on the TV screen. 2 Press V/v repeatedly to select " Settings," then press or b. The Settings menu list appears on the TV screen. continued 47GB