Sony TCD-D100 Operating Instructions primary manual - Page 18
microphones
View all Sony TCD-D100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Tip • When the tape-corder records to the end of the tape, it rewinds the tape automatically to the beginning and stops. (Auto-rewind function). Notes • The unit will not enter the low-power consumption mode during the recording monitor mode, even when using the unit on batteries. • Changing the sampling frequency while recording may cause temporary sound dropout to be recorded. • Noise may be recorded if you set the MIC/LINE IN switch during recording. • Noise may be recorded when the display light is turned on while recording. In this case, turn it off. • If CrE12 appears when the recording mode is set to AUTO (AGC), set the MIC An' to 20dB or move the microphone away from the sound source. To record relatively low sounds Lower the recording level (in the manual recording mode) and move the microphone as close as possible to the sound source and then adjust the recording level. Clear and optimum recording with minimal noise interferences will be achieved. Choosing microphones for better recording The recording is affected by and is dependent upon the type of microphones used. For better recording, use the optional ECM-MS957 or ECM-MS907 microphone. Compatible microphones • Optional plug-in power type microphones are compatible for this tape-corder. • Optional auto power supply type microphones are not compatible for this tape-corder. 18f" I Recording