Sony VPL-FHZ120L Operating Instructions - Page 13

Lever Attaching the Projection Lens Notes  Avoid removing/attaching the lens with the projector installed suspended from a ceiling.  For usable projection lenses, see "Optional accessories" (page 53).  Do not attach any lens other than the specified accessory lens sold separately.  Be careful not to drop the projection lens.  Avoid touching the lens surface. 1 Turn off the projector, then unplug the AC power cord from the wall outlet. Caution When replacing the lens, your eyes may be damaged if a strong light accidentally gets into your eyes. Before replacing the lens, turn off the projector and then unplug the AC power cord. 2 Remove the lens cover. While sliding the LENS COVER RELEASE buttons inward, pull out the lens cover until it clicks into place. LENS COVER RELEASE buttons 3 Turn the contact substrate to the left facing the front of the lens and insert the lens to the end. 4 While pressing the slide switch, lower the lever until it clicks into place. Lever Slide switch 5 Attach the lens cover. Hang the upper side of the lens cover on the top cover of the projector and press it until it clicks into place. Then, while sliding the LENS COVER RELEASE buttons inward, insert the lens cover. Even when the lens is attached, you can attach/ remove the lens cover in the same way. Removing the Projection Lens 1 Return the projection lens to the center position. While the projector is turned on, press the LENS SHIFT key on the Remote Commander, then press the RESET key on it. The projection lens returns to the center position. 2 Turn off the projector, then unplug the AC power cord from the wall outlet. Caution When replacing the lens, your eyes may be damaged if a strong light accidentally gets into your eyes. Before replacing the lens, turn off the projector and then unplug the AC power cord. 3 Remove the lens cover. 4 While pressing the slide switch, move the lever up to the limit, and pull the lens straight out. 5 Attach the lens cover. 13