Stihl FS 560 C-EM Product Instruction Manual - Page 27
Mounting the Cutting Attachment, Mounting Mowing Heads, Removing the mowing head, Mounting Grass
View all Stihl FS 560 C-EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
N Fit or remove the cutting attachment - see chapter on "Mounting the Cutting Attachment". N Remove the stop pin. Always remove the stop pin used to block the shaft since the drive train will otherwise be damaged when the engine runs. Mounting the Cutting Attachment Use a deflector that matches the cutting attachment - see "Mounting the Deflector". N Depending on the cutting attachment you are using, refer to the appropriate chapter below: - Mounting Mowing Heads - Mounting Grass Cutting Blades - Mounting Brush Knives or - Mounting Circular Saw Blades Mounting Mowing Heads All approved mowing heads are mounted to the gearbox in the same way. N Check that the deflector on the machine is approved for mowing heads - if not, perform the next two steps. N Remove grass shield with thrust plate - if fitted. N Remove the non-approved deflector. N Mount deflector for mowing heads. N Fit grass shield together with 2.4-in (60-mm) diameter thrust plate. 1 N Block the drive shaft. N Screw the mowing head counterclockwise onto the shaft (1) and tighten it down firmly. Removing the mowing head N Block the drive shaft. N Unscrew the mowing head clockwise. 002BA468 KN 681BA194 KN English Mounting Grass Cutting Blades N Check that the deflector on the machine is approved for grass cutting blades - if not, perform the next two steps. N Remove grass shield with thrust plate - if fitted. N Remove the non-approved deflector. N Mount deflector for grass cutting blades and brush knives. N Fit grass shield together with 2.4-in (60-mm) diameter thrust plate. Cutting edges of grass cutting blade 255-8 must point clockwise. FS 510 C-M, FS 560 C-M 25