Stihl FS 560 C-EM Product Instruction Manual - Page 30

4900BA016 KN English Fuel This engine is certified to operate on unleaded gasoline and STIHL twostroke engine oil at a mix ratio of 50:1. Your engine requires a mixture of highquality gasoline and two-stroke air cooled engine oil. Use mid-grade unleaded gasoline with a minimum octane rating of 89 (R+M/2) and no more than 10% ethanol content. Fuel with a lower octane rating may increase engine temperatures. This, in turn, increases the risk of piston seizure and damage to the engine. The chemical composition of the fuel is also important. Some fuel additives not only detrimentally affect elastomers (carburetor diaphragms, oil seals, fuel lines, etc.), but magnesium castings and catalytic converters as well. This could cause running problems or even damage the engine. For this reason STIHL recommends that you use only high-quality unleaded gasoline! Use only STIHL two-stroke engine oil or equivalent high-quality two-stroke engine oils that are designed for use only in air cooled two-cycle engines. We recommend STIHL HP Ultra 2-Cycle Engine Oil since it is specially formulated for use in STIHL engines. Do not use BIA or TCW rated (twostroke water cooled) mix oils or other mix oils that state they are for use in both water cooled and air cooled engines (e.g., outboard motors, snowmobiles, chain saws, mopeds, etc.). Take care when handling gasoline. Avoid direct contact with the skin and avoid inhaling fuel vapor. When filling at the pump, first remove the container from your vehicle and place the container on the ground before filling. To reduce the risk of sparks from static discharge and resulting fire and/or explosion, do not fill fuel containers that are sitting in or on a vehicle or trailer. The container should be kept tightly closed in order to limit the amount of any moisture that gets into the mixture. The machine's fuel tank should be cleaned as necessary. Fuel mix ages Only mix sufficient fuel for a few days work, not to exceed 3 months of storage. Store in approved fuel-containers only. When mixing, pour oil into the container first, and then add gasoline. Close the container and shake it vigorously by hand to ensure proper mixing of the oil with the fuel. Gasoline Oil (STIHL 50:1 or equivalent high-quality oils) US gal. 1 2 1/2 5 US fl.oz. 2.6 6.4 12.8 Dispose of empty mixing-oil containers only at authorized disposal locations. Fueling Preparations When fueling on a slope, always position the machine so that the filler cap is facing uphill. N On level ground, position the machine so that the filler cap is facing up. N Before fueling, clean the filler cap and the area around it to ensure that no dirt falls into the tank. Always thoroughly shake the mixture in the canister before fueling your machine. In order to reduce the risk of fire and personal injury from escaping gas vapor and fumes, remove the fuel filler cap carefully so as to allow any pressure build-up in the tank to release slowly. 28 FS 510 C-M, FS 560 C-M