Stihl FS 560 C-EM Product Instruction Manual - Page 47

Inspection and Maintenance by User Clamped Area of Handlebar 2 1 N Check the freedom of movement of the handlebar (1) in the clamp moldings (2) at regular intervals. Handlebar is difficult to move 3 1 N Loosen the wing screw (3) just enough for the handlebar to be moved. N Push the handlebar (1) sideways out of the clamp. N Soak a cloth in a clean, nonflammable cleaning solution - do not use cleaning agent containing oil or grease. 4900BA026 KN 4900BA025 KN N Thoroughly clean the clamp area of the handlebar with the cloth and cleaning solution. N Line up the handlebar and secure it in position with the wing screw. Handlebar cannot be clamped firmly in position N Release handlebar in clamp as described under "Handlebar is difficult to move". N Degrease clamp area on handlebar and in clamp moldings. N Line up the handlebar and secure it in position with the wing screw. Adjusting the Throttle Cable The throttle cable can be adjusted only when the machine is properly assembled. The control handle must be in the normal operating position. If the following adjustments do not produce the required result, have your servicing dealer repair the machine. STIHL recommends a STIHL servicing dealer. Check adjustment of throttle cable. Error: Engine speed increases when only the throttle trigger is depressed. English 1 2 N Starting the Engine N Depress the throttle trigger (2) - do not press down the throttle trigger lockout (1). If the engine speed increases or if the cutting attachment rotates, the throttle cable has to be adjusted. N Stopping the Engine Adjusting the Throttle Cable N Depress the throttle trigger lockout (1) and the throttle trigger (2) as far as stop and hold them in that position. Apply only sufficient pressure to hold the levers against their stops. N Rotate screw in throttle trigger 1/2 turn counterclockwise. N Release the throttle trigger and throttle trigger lockout. 002BA455 KN 6BA025 KN FS 510 C-M, FS 560 C-M 45