Stihl FS 560 C-EM Product Instruction Manual - Page 34

English If the cutting attachment rotates when the engine is idling, refer to notes in chapter on "Adjusting the Thottle Cable" or have the machine serviced by your dealer. STIHL recommends a STIHL servicing dealer. N Attach the machine to the shoulder strap. N Machine is ready for use. Stopping the Engine N Depress the momentary contact stop switch - the engine stops - release the stop switch - it springs back to the run position. 002BA485 KN 6BA024 KN Other Hints on Starting Starting for first time N Depress the throttle trigger - do not press down the throttle trigger lockout. If engine speed increases or the cutting attachment rotates: N Go to section "Stopping the Engine". N Go to "Adjusting the Throttle Cable". If the engine speed does not increase, your machine is ready for operation. At very low outside temperatures N Set the engine to winter operation if necessary, see "Winter Operation". N If the machine is very cold (frost on machine), allow the engine to warm up in the Start } position after starting until normal operating temperature is reached. Warning: the cutting attachment rotates in this position. At very high outside temperatures If the engine does not start after 10 pulls in the Start } position: N Start the engine in the Run F position. If the engine does not start N Check that all settings are correct. N Check that there is fuel in the tank and refuel if necessary. N Check that the spark plug boot is properly connected. N Repeat the starting procedure. Fuel tank run until completely dry N After refueling, press the fuel pump bulb at least five times - even if the bulb is filled with fuel. N Start the engine. 32 FS 510 C-M, FS 560 C-M