Stihl FS 560 C-EM Product Instruction Manual - Page 41
the carrier.
View all Stihl FS 560 C-EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
9926BA041 KN Releasing Tension on Rewind Spring Removing the Rope Rotor English 7 3 9926BA039 KN 9926BA036 KN 9926BA042 KN N Use the tensioning wrench. It is available as a special accessory. 3 2 2 5 N If necessary, swing the pawls (2) inwards. N Rotate the spring clip (3) out of the recesses (4) in the carrier (5). 6 4 N Position the tensioning wrench in the carrier so that the peg (6) engages one of the recesses (4). 9926BA038 KN 9926BA037 KN N Use starter grip to pull out the starter rope as far as stop. N Hold the tensioning wrench and the starter mechanism steady so that the rope does not rewind onto the rope rotor. N Grip the rope inside the housing, pull it out to its full length and make a loop. N Allow tensioning wrench to rotate slowly and thus release spring tension - the rope winds itself around the tensioning wrench in this process until the spring is no longer under tension. N Remove the tensioning wrench from the carrier. 9926BA040 KN N Use a screwdriver or suitable pliers to remove the spring clip (3) from the starter post. N Carefully remove the E-clip (7). 9 5 2 8 N Carefully remove the carrier (5) with pawls (2) and washer (8) and put them to one side so that the pawls and washer cannot fall out. N Pull the rope rotor (9) off the starter post. The rewind spring may pop out and uncoil during this operation - take care to avoid the risk of injury. FS 510 C-M, FS 560 C-M 39