Sub-Zero 427R Wine Storage Installation Instructions - Page 17

Models 427G and 427RG Installation 17 subzero.com Models 427G and 427RG Installation Make sure that the finished rough opening where the wine storage unit is to be installed is properly prepared. Refer to the opening dimensions illustrations for models 427G and 427R on the previous page. IMPORTANT NOTE: The floor under the wine storage unit must be at the same level as the surrounding finished floor to allow for removal of the unit for servicing. IMPORTANT NOTE: To operate properly, the door must open a minimum of 90°. Use a minimum 2" (51) filler in corner installations to assure a 90° door opening. Allow enough clearance in front of the unit for full door swing. IMPORTANT NOTE: The inside edges of the rough opening, as well as the sides and a portion of the backside of the decorative panels will need to be finished, as they will be exposed when the doors are open. OPENING DIMENSIONS 25" (635) OPENING DEPTH TOP VIEW TOOLS AND MATERIALS REQUIRED • Appliance dolly able to support 500 lbs (227 kg) and adequate manpower to handle the weight of the unit. • Phillips and slotted screwdrivers. • Allen, standard and crescent wrenches. • Various sized pliers. • 5/16" hex bolt nut driver. • Cordless drill and assorted drill bits. • Level-2' (.6 m) and 4' (1.2 m) recommended. • Masonite, plywood, pressed fiberboard, cardboard or other suitable material to protect finished flooring. • Appropriate materials to cover and protect the home and furnishings during installation. Do not load wine into the wine storage unit until the installation is complete. 25" (635) OPENING DEPTH 80" (2032) OPENING HEIGHT 27" (686) OPENING WIDTH SIDE VIEW FRONT VIEW IMPORTANT NOTE: The depth of each integrated model is 24" (610) from the front of the unit to its back. Your design may necessitate moving the unit back or cabinets forward to achieve a flush fit. This will require a minimum rough opening depth of 25" (635).