Sub-Zero 427R Wine Storage Installation Instructions - Page 25

Models 427G and 427RG Installation 25 subzero.com Kickplate/Grille Installation Once the wine storage unit is leveled and wiring connections made, the kickplate/grille can be installed. The mounting bracket may be adjusted slightly forward or back so the kickplate/grille will fit flush with the surrounding area. Refer to the illustration below. The kickplate/grille must be removable for service. The floor cannot interfere with removal. Turn power back on to the electrical outlet. IMPORTANT NOTE: The unit must be allowed to have ventilation through the fins of the kickplate/grille. You may cover the solid area, but do not block the fins. The door panel or the lower drawer panel may hang in front of the fins, but the baseboard molding must not cover them. If you choose, the kickplate/grille may be painted another color. Follow these steps: Rough up the surface to be painted with fine grit sandpaper. Wipe with alcohol to ensure that the surface is clean and dry. Use an appliance or industrial grade, oil base, high gloss enamel paint. MOUNTING BRACKET Door Panels Models 427G and 427RG have a full-view glass door. Each of these wine storage units are set up at the job site as either the stainless steel or integrated design. Stainless steel panels are available as sales accessories and are shipped separately. Stainless steel panels are shipped with matching handles in place. The integrated design uses custom wood or other decorative panels and handles provided by the customer. Model 427RG requires solid panels on the drawers that may match the door panel, or be complementary. The model 427RG stainless steel drawer panel set and stainless steel door panel are ordered and shipped as two items. Before beginning installation, check for the correct components for the fit and finish desired. The door and drawers (model 427R) require a decorative panel that is a minimum 5/8" (16) thick. IMPORTANT NOTE: For installations at or above 5,000' (1524 m) in altitude, a special high altitude glass door unit (HAG) must be ordered. If you have questions, contact your authorized Sub-Zero dealer or cabinet supplier. Additional panel information can be found in the Sub-Zero design guide, or visit our website at subzero.com. A solid panel cannot be installed over the glass door, as this may cause moisture to form behind the panel. Kickplate/grille installation.