Sub-Zero 427R Wine Storage Installation Instructions - Page 51

Model WS-30 Installation 51 subzero.com Dual Installations DUAL FLUSH INSET INSTALLATIONS Installing two models WS-30 or a model WS-30 and built-in unit side by side in a flush inset application will require adjustments to the dimensions of your finished rough opening, panel sizes and panel offsets. It will also require a dual installation kit, available through your authorized Sub-Zero dealer. Dual installations without a filler strip can only be accomplished using two units with opposite hinges as shown in illustration A below. The dual installations shown in illustrations B and C require a filler strip. Illustration A is the only application that will accommodate the dual wide grille. IMPORTANT NOTE: The application shown in illustration A can only be achieved by installing dual flush inset panels. Failure to install dual flush inset panels will cause the handle side of the panels to collide when closing. In this application a dual installation accessory kit is also required. Dual flush inset panels and dual installation kits are available through your authorized Sub-Zero dealer. Refer to the illustration and chart for dual flush inset panel specifications. Flush Inset Panels-Dual Installation H A A A H A W Model WS-30 DOOR Flush Inset Panel Spacer Panel Backer Panel GRILLE Flush Inset Panel Spacer Panel Backer Panel WINDOW Cut-Out Location W 301/2" (775) 291/8" (740) 293/4" (756) H 693/4" (1772) 6815/16" (1751) 699/16" (1767) W 301/2" (775) 291/8" (740) 293/4" (756) H 91/4" (235) 85/16" (211) 815/16" (227) W 23" (584) H 621/4" (1581) A 33/4" (95) Grille panel dimensions listed are for a standard 84" (2134) overall height of the unit. For an 83" (2108) overall height, subtract 1" (25) from grille panel height dimensions. For an 88" (2235) overall height, add 4" (102) to height dimensions. Width dimensions do not vary.