TP-Link T1500G-8T T1500G-10PSUN V1 CLI Reference Guide Guide - Page 240

Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example For VLAN 2, specify its query-interval as 200 seconds, and the response-time as 20 seconds: T1500G-10MPS(config)#ip igmp snooping querier vlan 2 query-interval 200 T1500G-10MPS(config)#ip igmp snooping querier vlan 2 max-response-time 20 24.17 ip igmp snooping max-groups Description The ip igmp snooping max-groups command is used to configure the maximum number of groups that a port can join in. The ip igmp snooping max-groups action is used to configure the action that the port takes when it receives an IGMP report message and the maximum number of entries is in the forwarding table. To remove the maximum group limitation and return to the default of no limitation on the specified port, please use the no ip igmp snooping max-groups command. To return to the default action of dropping the report, please use the no ip igmp snooping max-groups action command. These commands only apply to the dynamic multicast groups. Syntax ip igmp snooping max-groups [ maxgroup ] ip igmp snooping max-groups action { drop | replace } no ip igmp snooping max-groups no ip igmp snooping max-groups action Parameter maxgroup -- Specify the maximum numbers of groups that the port can join. It ranges from 0 to 1000 and the default value is 1000. drop -- When the number of the dynamic multicast groups that a port joins has exceeded the max-group, the port will not join any new multicast group. 227