TP-Link T1500G-8T T1500G-10PSUN V1 CLI Reference Guide Guide - Page 88
ip arp inspection limit-rate
View all TP-Link T1500G-8T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable the arp defend function for the Gigabit Ethernet ports 1/0/2-6: T1500G-10MPS(config)#interface range gigabitEthernet 1/0/2-6 T1500G-10MPS(config-if-range)#ip arp inspection 9.4 ip arp inspection limit-rate Description The ip arp inspection limit-rate command is used to configure the ARP speed of a specified port. To restore to the default speed, please use no ip arp inspection limit-rate command. Syntax ip arp inspection limit-rate value no ip arp inspection limit-rate Parameter value --The value to specify the maximum amount of the received ARP packets per second, ranging from 10 to 100 in pps(packet/second). By default, the value is 15. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Configure the maximum amount of the received ARP packets per second as 50 pps for Gigabit Ethernet port 5: T1500G-10MPS(config)#interface gigabitEthernet 1/0/5 T1500G-10MPS(config-if)#ip arp inspection limit-rate 50 75